Interface: TDOT Connected Vehicle Roadside Equipment - THP Weigh-In-Motion
Architecture Flow Definitions
driver log (Planned) Applicable ITS Standards
A daily log showing hours in service for the current driver. The query flow is not explicitly shown.
electronic screening request (Planned) Applicable ITS Standards
Request for identification data to support electronic screening.
freight equipment information (Planned) Applicable ITS Standards
Container, trailer, or chassis information regarding identity, type, location, brake wear data, mileage, seal #, seal type, door open/close status, chassis bare/covered status, tethered / untethered status, temperature, humidity, power, battery levels, brake wear data, and bill of lading/information regarding the cargo/content.
on-board safety data (Planned) Applicable ITS Standards
Safety data measured by on-board sensors. Includes information about the vehicle, vehicle components, cargo, and driver. The query flow is not explicitly shown.
pass/pull-in (Planned) Applicable ITS Standards
Command to commercial vehicle to pull into or bypass inspection station.
screening event record (Planned) Applicable ITS Standards
Results of CVO electronic screening activity.
unique identifiers (Planned) Applicable ITS Standards
Unique identifiers for the motor carrier, driver, and vehicle. This flow identifies the driver actually operating the vehicle in multi-driver scenarios.