Interface: TDOT Connected Vehicle Roadside Equipment - THP Weigh-in-Motion
Information Flow Definitions
driver log (Planned)
A daily log showing hours in service for the current driver. The query flow is not explicitly shown.
electronic screening request (Planned)
Request for identification data to support electronic screening.
freight equipment information (Planned)
Container, trailer, or chassis information regarding identity, type, location, brake wear data, mileage, seal #, seal type, door open/close status, chassis bare/covered status, tethered / untethered status, temperature, humidity, power, battery levels, brake wear data, and bill of lading/information regarding the cargo/content.
on-board safety data (Planned)
Safety data measured by on–board sensors. Includes information about the vehicle, vehicle components, cargo, and driver. The query flow is not explicitly shown.
pass/pull-in (Planned)
Command to commercial vehicle to pull into or bypass inspection station.
screening event record (Planned)
Results of CVO electronic screening activity.
unique identifiers (Planned)
Unique identifiers for the motor carrier, driver, and vehicle. This flow identifies the driver actually operating the vehicle in multi–driver scenarios.