Interface: BMS Multi-Agency Command Center - TDOT Reversible Lane Equipment
![BMS Multi-Agency Command Center to TDOT Reversible Lane Equipment Interface Diagram](../../images/ifs/if23-220.gif)
Architecture Flow Definitions
lane management control (Planned) Applicable ITS Standards
Information used to configure and control dynamic lane management systems.
lane management information (Planned) Applicable ITS Standards
System status including current operational state, violations, and logged information.
reversible lane control (Planned) Applicable ITS Standards
Control of automated reversible lane configuration and driver information systems.
reversible lane status (Planned) Applicable ITS Standards
Current reversible lane status including traffic sensor and surveillance data and the operational status and mode of the reversible lane control equipment.
signal control commands (Planned) Applicable ITS Standards
Control of traffic signal controllers or field masters including clock synchronization.
signal control device configuration (Planned) Applicable ITS Standards
Data used to configure traffic signal control equipment including local controllers and system masters.
signal control plans (Planned) Applicable ITS Standards
Traffic signal timing parameters including minimum green time and interval durations for basic operation and cycle length, splits, offset, phase sequence, etc. for coordinated systems.
signal control status (Planned) Applicable ITS Standards
Operational and status data of traffic signal control equipment including operating condition and current indications.
signal fault data (Planned) Applicable ITS Standards
Faults from traffic signal control equipment.
signal system configuration (Planned) Applicable ITS Standards
Data used to configure traffic signal systems including configuring control sections and mode of operation (time based or traffic responsive).